Torque tube support
|
|
Torque tube support |
|
|
 |
Navigation & Acknowledgements |
Tailplane torque tube support: 2013-06-24
Panasonic Lumix DMC-FT1
The tailplane torque tube supported by a device made from an old pallet. I sawed off a piece of the pallet and used some of the offcut pieces to make vertical supports, by bolting them to the spacer blocks. Each vertical piece has a semi-circular notch at the top to keep the torque tube in place.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2013-07-07. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||