making pulley guard for sight gauge tubing
|
|
making pulley guard for sight gauge tubing |
|
|
 |
Navigation & Acknowledgements |
making guard for rudder cable pulley: 2022-01-28 Panasonic DMC-FT1
Making a guard to fit between the port rudder cable pulley and the fuel sight gauge tubing. A strip of 6061 T6 aluminium clamped under the seatbelt bolt access hole and marked for trimming. The aft end of the strip is bent down over the pulley and under the tubing.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2022-03-06. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||