machining vacuum adaptor
|
|
machining vacuum adaptor |
|
|
 |
Navigation & Acknowledgements |
machining vacuum adaptor: 2014-03-31
Lumix DMC-FT1
Machining the adaptor for the artificial horizon on the lathe from a piece of 3/4" hex aluminium bar. This is the 3rd one I made; I was unhappy with the second one and decided to try again, leaving a bit more length on the hex section so the NPT tapping didn't come too close to the edges.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2014-06-28. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||