tank vent assembly curing
|
|
tank vent assembly curing |
|
|
 |
Navigation & Acknowledgements |
fuel tank vent assembly curing: 2016-03-12 Panasonic DMC-FT1
Here is a AN823-6D elbow that has been modified by opening up the bore of the 1/4" NPT end with a letter W drill bit to accept a length of 3/8" OD aluminium tube. The tube has been bent slightly so that it will reach into the top corner of the fuel tank when fitted, and is now being bonded to the AN823-6D fitting at the correct angle with Redux (Araldite 420). The assembly is curing in the boiler cupboard where (as the display indicates) the climate is warm and dry.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2016-04-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||