 |
masking outside of starboard door glazing
|
 |
masking outside of starboard door glazing
masking outside of starboard door glazing: 2022-10-31 Panasonic DMC-FT1
Polyethylene sheet attached to the outer face of the Perspex, taped down around its edges flush to the edge of the glazing. The wide green masking tape was applied to overshoot slightly beyond the edge then trimmed back flush with a scalpel. This is to ensure that no Redux or sticky fingerprints can get onto any art of the outer surface of the Perspex. The trial fittings of the Perspex to check the edge trimming showed that it's difficult to handle the glazing and get it correctly positioned without accidentally touching areas that should not be bonded.
|
This page last updated 2022-12-02.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages