Finishing rudder port side
|
|
Finishing rudder port side |
|
|
 |
Navigation & Acknowledgements |
4 pictures on this page - scroll down to see the rest
Rudder port side with Dry Guide Coat: 2007-08-27.
Nikon Coolpix 8400.
The port side of the rudder with 3M Dry Guide Coat applied, ready for rubbing down with 240 grade wet-and-dry. The small dark circles are where I used the Sandvik abrader to remove high spots - the DGC adheres better to surfaces with rougher textures.
Slurry on port side of rudder: 2007-08-27.
Nikon Coolpix 8400.
The port side of the rudder after some rubbing down with 240 grade wet-and-dry, showing the grey slurry that accumulates.
Port side of rudder rinsed off: 2007-08-27.
Nikon Coolpix 8400.
The port side of the rudder after rinsing off the slurry. Note how the low (grey) areas are now much easier to see.
Rudder port side polished: 2007-08-27.
Nikon Coolpix 8400.
The port side of the rudder after rubbing down with progressively finer abrasive to 2000 grade, then polishing with Farecla G3.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2013-10-16. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||