 |
fuel weight sensor scale adjuster
|
 |
fuel weight sensor scale adjuster
fuel weight sensor adjustment hole: 2022-01-03 Panasonic DMC-FT1
One of the pins on the pressure sensor broke because of excessive handling. I re-soldered the sensor to the PCB with all pins shortened. That meant that the PCB had to be located in a different slot, so the pressure & vent tubes would line up with the holes in the box. That in turn meant that the hole for access to the sensitivity trimpot needed to be adjusted. Rather than drilling a new hole, I filed the existing one into a slot.
|
This page last updated 2022-02-05.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages