 |
mesh for cooling fan
|
 |
mesh for cooling fan
mesh for fan aperture: 2020-05-09 Panasonic DMC-FT1
Preparing to reinforce with epoxy the edges of the mesh which will cover the fan aperture. The gray rectangle is card with a tracing of the holes in the top of the F14 Instrument Module. Covering that is a sheet of polyethylene, and the mesh on top of that. After spreading epoxy around the edge of the mesh to reinforce the area where the fixing holes will be, another sheet of polyethylene will be applied over the epoxy and the whole assembly pressed between a couple of boards to keep it flat.
|
This page last updated 2020-06-02.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages