 |
Bridge to hold down tubing clips
|
 |
Bridge to hold down tubing clips
tubing clip hold-down bridge: 2008-02-14.
Nikon Coolpix 8400
I found that simply putting a weight on the centre of the double clip while the adhesive was curing tended to make the ends bow upwards, making for a poor bond. I sliced up some of the wooden slats (once part of a louvre door), that had also been used as formers when making the clip layup, to form bridges that would ensure the weight was transferred to the end flanges of the clips.
|
This page last updated 2012-12-12.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages