 |
kink in fin splash moulding
|
 |
kink in fin splash moulding
wrinkled splash moulding: 2013-09-16
Panasonic Lumix DMC-FT1
I made this splash moulding on the inside of the fin, to make it easier to add the BID tapes bonding the rear bulkhead to the fin. The layup has sagged a bit in the centre before it cured and I was concerned I might have to re-make it, but the sagged area is all forward of the bulkhead and so not important.
|
This page last updated 2014-06-29 15:19.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages