Bonding in FL18s
|
|
Bonding in FL18s |
|
|
 |
Navigation & Acknowledgements |
2 pictures on this page - scroll down to see the rest
bonding FL18S: 2015-03-09
Lumix DMC-FT1
Bonding in FL18S with Redux. Mixing sticks have been inserted below FL18S to support it in the correct position. The aluminium-angle straight-edge which keeps FL18S & FL18P in alignment with each other is attached with sacrificial nylon screws which will be drilled out when the Redux is cured. The nylon screws have countersunk heads and the size was chosen so that the heads lie almost flush with the undersurface of the FL18s.
bonding FL18P: 2015-03-09
Lumix DMC-FT1
Bonding in FL18P with Redux. Mixing sticks have been inserted below FL18P to support it in the correct position. The aluminium-angle straight-edge which keeps FL18S & FL18P in alignment with each other is attached with sacrificial nylon screws which will be drilled out when the Redux is cured. The nylon screws have countersunk heads and the size was chosen so that the heads lie almost flush with the undersurface of the FL18s.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2015-04-08. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||