bonding clip on fuel weight sensor vent tube
|
|
bonding clip on fuel weight sensor vent tube |
|
|
 |
Navigation & Acknowledgements |
fuel weight sensor vent tube clip bonding: 2022-01-08 Panasonic DMC-FT1
In order to keep the vent tubing from the fuel weight sensor in place (so that it cannot be accidentally crushed by the seat pads) I bonded a clip to the seatpan. I used one made earlier for other purposes and cut off one "leg" as it had the fit close to the tunnel. Here are 2 lead weights keeping it in place while the epoxy cures.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2022-02-05. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||