milling shoot-bolt pushrods
|
|
milling shoot-bolt pushrods |
|
|
 |
Navigation & Acknowledgements |
2 pictures on this page - scroll down to see the rest
milling flats on door bolt pushrod: 2022-06-18 Apple iPhone 8
One of the door shoot-bolt aft pushrods on the milling table. It is gripped at the right by the milling vise, with card softening in the jaws, and supported at the left on a VEE-block. This setup is for milling flats on the pushrod to make a narrow section which will allow the locking hooks to pass on each side.
flats milled on door bolt pushrod: 2022-06-18 Apple iPhone 8
One of the door shoot-bolt aft pushrods after milling flats on it to accept the locking hooks.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2022-07-14. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||